|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
how to tell what size A,B,C,D?
are there any marks on the cylinder I can look for to determine if i have a A,B,C,D size cylinder?
|
#2
|
||||
|
||||
The letter is stamped on the back of the cylinder near the bottom.
|
#3
|
||||
|
||||
On my 99 EC200 it is marked on the back of the cylinder, just about the reed cage.
I would assume that if your asking, then yours is not marked? Next time your due for a topend, remove the cylinder and have it measured a good shop can do that for you. I think it is check in 3 different locations of the cylinder. Based upon those numbers then you can check your piston options. Hope that helps.
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#4
|
|||
|
|||
I looked all over the back and there is no mark, i was searching wiseco pistons and to me it seems like they only come in one size for my 2005 200. so does the size really matter?
|
#5
|
||||
|
||||
Quote:
http://www.wossnerpistons.com/produc...ame=2+Off-road
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#6
|
||||
|
||||
To answer your question, yes it matters. If it is too loose it will not perform as well as it can. If it is too tight you could have problems with seizing. Since it is a 2005 and you have it apart, I assume it has some miles on it and needs a rebuild. If you can feel any ridge at the top of the cylinder, I would get it diamond honed and measured so you don't waste money, time and HP.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GG 200 size | Darkside | General Discussions & Announcements | 21 | 01-31-2012 10:57 PM |
what size weight? | boostedte37 | General Discussions & Announcements | 11 | 01-17-2010 06:12 PM |
Bib Mousse size? | gasgasman | Enduro Chassis & Body | 2 | 10-24-2008 05:08 PM |
Nut Size | steve | Enduro Engine - 2 stroke | 2 | 01-11-2008 10:58 AM |