|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
clutch slave cylinder hydraulic seal
Hi, I have a leak from behind the piston in the clutch slave cylinder, I can't see how to get it out of it's 'seat'.
I can't use the lever as there is no fluid pressure, even after bleeding. Anyone know? Cheers its a 2010 ec250 2t 6 days model. |
#2
|
||||
|
||||
Cover the piston with a rag & SLOWLY blow air into the fitting where line hooks up. It will push the piston out. Careful not to blow the piston across the room though (thus the rag & slow fill with air)
__________________
Fred Overstreet 2010 EC250 SixDays 2004 GasGas EC300 -Sold to a good home 2006 GasGas EC250-Sold to a good home 2006 GasGas TXT 280 Pro |
#3
|
||||
|
||||
If the master is still attached you can pull the lever repeatedly until it comes out.
|
#4
|
|||
|
|||
Cheers fella's will try the lever first, then air.
thanks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rekluse Adjustable Slave Cylinder | Fred1956 | Enduro Product Reviews | 16 | 03-27-2013 09:54 AM |
Rekluse adjustable slave cylinder | Fred1956 | Enduro Product Announcements | 0 | 11-28-2012 08:50 PM |
Clutch Slave Cylinder Rebuild | newgaser | Enduro Engine - 2 stroke | 5 | 03-17-2012 08:30 AM |
slave cylinder | new gas gas | Enduro Engine - 2 stroke | 0 | 11-14-2008 04:47 PM |
Oil around Clutch Slave | rickster2 | Enduro Engine - 2 stroke | 5 | 08-29-2006 11:27 AM |