|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Sharp and loud engine sound
Hi,
As already told in a previous post that youve might have read, I had a spooge problem, which seems to be better. Today a friend of mine rode my bike and I was standing there without a helmet and my god its really really loud. It sounds like someone is hitting cooking pots. Muffler packing is a little black but in good condition in my opinion. The rubber sleeve that connects the pipe and muffler is New so that should be good. I have 2 Air intakes on each side of the airbox, might these cause that sound The pipe is an FMF. Bike a 2012 ec300. Anyone has got some tips? Grts! Verstuurd vanaf mijn XT1572 met Tapatalk |
#2
|
||||
|
||||
Have a listen to the video from this thread. Sound the same?
http://www.gasgasrider.org/forum/sho...ght=chain+slap
__________________
15 GASGAS EC 250 19 Sherco SE 125R |
#3
|
|||
|
|||
Check the seal between the exhaust pipe and cylinder/spigot?
|
#4
|
|||
|
|||
Mine was really loud and raspy when I got it. The exhaust packing looked okay on the outside but inside it was clogged, as were the holes on the pipe. I cleaned all the holes out (which was a messy and crap job!) and replaced the packing. Now its a totally different quieter sound.
|
#5
|
|||
|
|||
Tiddles, what packing did you use? Mats of fiberglas? I dont really know the english word for it so I hope you understand what I mean
Verstuurd vanaf mijn XT1572 met Tapatalk |
#6
|
|||
|
|||
I've always just called it 2 stroke exhaust packing, you can find it on eBay, amazon ect.
|
#7
|
|||
|
|||
I use this stuff
http://www.ebay.co.uk/itm/Acousta-Fi...IAAOSwofxUfQ5l And it seems to do what they say in the advert. Cleaning out the holes on the perforated pipe will have helped a lot too though. Ade |
#8
|
|||
|
|||
This is what came out of mine. Last edited by Tiddlesrx7; 06-06-2016 at 04:49 PM. |
#9
|
||||
|
||||
Quote:
Very similar. Hadn't soaked right through but clogged up the core. Haven't started it but imagine will be back to its old self. |
#10
|
|||
|
|||
I just cut up some ROXUL sound insulation and use that. I usually always have some laying around from a job. It works as well as the store bought stuff.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bike sometimes gets loud over whoops | 3beejay3 | General Discussions & Announcements | 10 | 09-09-2013 08:42 PM |
engine rebuild aftermath - i dont think this ia a good sound? | rgranger | Enduro Engine - 2 stroke | 3 | 03-03-2013 09:33 PM |
How sharp are you guys? | GMP | General Discussions & Announcements | 13 | 06-19-2012 08:54 AM |
sound of the engine | 300ec | Enduro Engine - 2 stroke | 10 | 02-15-2012 02:14 PM |
Engine sound decel | Jakobi | Enduro Engine - 2 stroke | 48 | 07-06-2011 11:44 PM |