|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
08 250 DE with 03 250 EC IMS tank - Pictures
It took me about an hour and half to get it all bolted up and ready to go. Two people could make things go alot quicker.
I used a 1999 KX250 front number plate. I just guessed on the year of the number plate when I ordered it. I knew the older KX250 plates worked but, wasn't sure on the correct year. It fits! (with some modding, of course) |
#2
|
|||
|
|||
looks nice and neat, what did you have to do to make it fit? How much fuel does it actually hold?
Phill |
#3
|
|||
|
|||
Quote:
Repeat for the other side. I cut the slot, where the tank hooks to the seat, back about 1/4 of an inch. Again, it helps to have a 2nd person when you install the seat too. Once I got the seat bolted down; I used a tie down to pull the seat down to form a better fit. I would reccomend putting something between the tie down strap and the seat cover so you don't get a little indention. |
#4
|
|||
|
|||
How much modding did you have to do to get the kx front plate to fit up.
I am looking for a plate to replace the headlight on my 07 ec and the gasgas part is $145nz which i don't really want to spend compared to about $30-40 for a japanese part. |
#5
|
|||
|
|||
Quote:
Then you just put in the bolt that connects the plate to the top 3x clamp and put 2 zip ties to the forks. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Denver Endurocross Day Pictures 10/30/2010 | coopernicus | Pictures & Videos | 3 | 10-31-2010 09:23 PM |
GasGas Pictures dont match? | dank | General Discussions & Announcements | 10 | 10-03-2010 05:34 PM |
How to upload pictures | Spitfire77 | General Discussions & Announcements | 2 | 09-23-2010 12:09 PM |
Pictures of Shifter Spring | gasser | General Discussions & Announcements | 0 | 07-11-2009 08:06 PM |