|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Shiver 45 2011 Midvalve or check valve?
Hi Folks,
Was delving into the forks last night to swap to some heavier springs and change the stacks. (Springs are incorrect sold as 0.48kg/m but are same in every way to my original 0.42 so waste of time anyway lol) I got the rebound piston off and found this arrangement. Is it a very heavy check valve or an attempt at mid valve? Damper rod Spring 6x 14.3 1x 23.3 Piston Rebound stack Nut. I looked through the shiver manual and it only shows a single shim with the spring to operate as a check valve on the rebound piston. Cheers |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shiver 45 base valve | sam097 | Enduro Suspension | 10 | 02-23-2017 10:48 PM |
Marzocchi Shiver 45 lower valve parts? | brider | Enduro Suspension | 4 | 04-13-2015 06:16 PM |
carb. vent hose check valve | john r b | Enduro Intake/Carburetion - 2 stroke | 5 | 05-15-2014 01:30 PM |
FSR 450 valve check and timing chain | ggg | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 04-22-2010 01:40 AM |
Marzocchi 45mm mid valve check plate | stay_upright | Enduro Suspension | 10 | 04-02-2010 12:37 AM |