|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Etched Needle
I just broke down and ordered a JD jetting kit for my 2011 EC 300. The red needle has fine little etch marks in the mid and tip of the needle. I called and spoke to a lady at JD jetting and said that was within normal limits for the needles. She stated that it would not change it's function. I figured I would ask you all. Would fine etch marks change the function of a carb needle? I have never seen any marks in a needle before.
Thanks. |
#2
|
||||
|
||||
I would say she's right.I've never seen etch marks on any needle and doubt that they will effect performance.They shouldn't been sent out though,imo.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
needle | jimjim | Enduro Intake/Carburetion - 2 stroke | 4 | 07-23-2011 07:07 AM |
CHN Needle | nsgasser | Enduro Intake/Carburetion - 2 stroke | 3 | 05-21-2011 11:18 PM |
CCK needle | pevs | Enduro Intake/Carburetion - 2 stroke | 2 | 02-25-2010 02:04 PM |
What needle is this? | bitoman | Enduro Intake/Carburetion - 2 stroke | 4 | 07-28-2009 04:26 PM |