|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
alternative to stock bars on '06 EC300?
I'll try to post a photo, but the stock bars on my '06 EC300 (got it used) have a bend that kicks my elbows out too far, and won't allow my clutch lever to rotate down far enough because the banjo fitting hits the bend in the bar. The position of the lever makes me look like a squid with it pointing way too level or "flat", rather than down, like I like it.
Does anyone have a suggested replacement bar that works? |
#2
|
||||
|
||||
Quote:
Moose makes a Burleson bend bar and also an XC bend that are short already, and basically a very high CR High bend. I like the look of them, and have a pair that I'm going to try when I next change grips. I like the TrailTech bar, but it came too long and I had to cut it off and drill it out to compensate for the length of the bark buster anchors. The old favorite Pro Taper Hawkins High bend bars are now the Woods Hight bend and now are 32" wide. When cut down to size, I had to drill the ends on them, also. I couldn't believe that they had changed them. .
__________________
Jim Cook Smackover Racing Team LAGNAF '11 Gas Gas EC250 (primary ride) '06 Gas Gas DE300 2004 Gas Gas TXT300 Pro '94 Husaberg FE350 '86 Yamaha IT200 '86 Honda TRL200 Reflex '04 KTM 525EXC (soon to be dual sported) Several others, including project bikes, Deb's bike, and a fleet of grandkids' bikes Let's go riding! http://www.jebruns.com/Wudi19/wudi19.html http://www.ahrma.org/schedules-results/cross-country/ |
#3
|
||||
|
||||
I run CR high and Yamaha high bend mini bars.
They do not need to be cut down and bark busters/controls fit like they should.
__________________
2003 GG 300EC/DE [Ohlins] 2001 GG 250XCSOLD |
#4
|
||||
|
||||
Quote:
Where did you fine the CR High bend minibike bars, and what brand? How are they designated? Are they available in aluminum and/or oversized? Thanks in advance! Jim .
__________________
Jim Cook Smackover Racing Team LAGNAF '11 Gas Gas EC250 (primary ride) '06 Gas Gas DE300 2004 Gas Gas TXT300 Pro '94 Husaberg FE350 '86 Yamaha IT200 '86 Honda TRL200 Reflex '04 KTM 525EXC (soon to be dual sported) Several others, including project bikes, Deb's bike, and a fleet of grandkids' bikes Let's go riding! http://www.jebruns.com/Wudi19/wudi19.html http://www.ahrma.org/schedules-results/cross-country/ |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stock Gasser bars???? | desertgasser300 | Enduro Chassis & Body | 12 | 01-11-2012 12:48 PM |
What size are stock 2006 EC300 bars? | 06EC300 | Enduro Chassis & Body | 1 | 12-22-2011 03:04 PM |
Stock HEbo Bars 1-1/8 ? | biggstr6 | General Discussions & Announcements | 4 | 10-30-2009 07:04 AM |
Stock '07 bars | ktmguy23 | Enduro Chassis & Body | 2 | 03-24-2009 07:52 AM |