|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
wont run
im at a loss. 2004 EC300, recent complete new topend(S3 barrel piston & head). went for a nice 4 hr ride. came home washed the bike put it away till the next weekend when the next ride was planned, got to the track and bike dead. checked spark none so thought plug was gone. replaced plug nothing still. stuffed around with wires removed all kill switch wires from bike(unpluged from CDI), sanded earth places. now have good strong spark(will junp 5mm plus the plug gap and crisp blue) thought sweet im off but got nothing. pulled carby cleaned and checked float level, put back together. i have nice strong spark, i have fuel, i have compression(170psi roughly) but i have no bang. i am getting to the point of pouring fuel over it and burning it. can anyone give me any insight TIA
|
#2
|
||||
|
||||
Do a leak down test to make sure the crank case is well sealed,
Check the reeds for damage. Make sure the muffler isn?t blocked, (broken baffle etc) mine did that first ride.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#3
|
||||
|
||||
Well at least try some spray ether engine start. Remove filter and spray in carb.
If it starts clean carb.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#4
|
||||
|
||||
Just because you have spark doesn't mean it's strong enough to spark under cylinder pressure. I would be willing to bet it's still an electrical problem since this is what started this unless you somehow got water in the carb. I would be checking stator output and checking the ignition coil.
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
#5
|
||||
|
||||
Also is the plug coming out wet? Dripping? It might have a crankcase of fuel from a flooding carb or fuel tap left on whilst trailering. Gassers have a nice Allen bolt in the cases to drain and check.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#6
|
|||
|
|||
@SS109 do you mean check voltage coming out of stator? the stator resistance is with FSM spec, as stated the spark is jumping across a gap of at least 5mm(tool a gocarting mate gave me) that i placed between plug lead and plug whilst plug is in the engine so that there is load
@Gasser Nate reeds are new as replaced them with the new top end, how to do leakdown test ill research thx @(F5) was the 1st thing i tried mate good sugestion guys thx for the responses |
#7
|
|||
|
|||
gasser nate plug is wet but not dripping ill have to have a squiz at that drain bolt thx
|
#8
|
|||
|
|||
Maybe have a look and see if the stator has rotated and the timing is off. Maybe you had it off when doing the previous work and it didn’t get tightened?
Sent from my iPhone using Tapatalk |
#9
|
||||
|
||||
Also make sure the flywheel?s key way is still intact.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#10
|
||||
|
||||
And the Key too ;-)
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wont start GG 04 450 | chaddlez | Enduro Engine 4 stroke (including EFI & Exhaust) | 9 | 03-26-2016 01:12 PM |
400 fse wont tick over | Ignas | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 01-01-2015 04:51 PM |
Why wont it run? Please help | fastisbetter | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 12-26-2014 08:34 PM |
my first gas gas wont start? | Southuist | Enduro Engine - 2 stroke | 6 | 03-14-2014 09:59 AM |
02 EC 300 wont start | GENO 300 | Enduro Engine - 2 stroke | 0 | 09-21-2009 10:02 PM |