|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
My main bearings
So my mains are toast and was reading this thread http://www.gasgasrider.org/forum/showthread.php?t=12276 for part numbers.
I have an 02 XC300, would these be the ones I need as well? Thanks and Cheers |
#2
|
||||
|
||||
Yes, those listed by the last post. They have been OEM from '02 to '07.
|
#3
|
|||
|
|||
Thank you Sir.
Questions: Can I use the C part number at a quality bearing manufacture source? I'm in the US, can anyone refer me to a good one? Thanks |
#4
|
||||
|
||||
I use these guys:
http://worldwidebearings.com They have been great and are very knowledgable, used to supply GGNA and Ty Davis's team. The "C" is the clearance spec, which is always C3 or C4 for a main bering in a two stroke application. C3 is good. You could actually go different ways with this: the OEM parts, the newer sealed ball bearing replacements, or heavy duty M series open ball bearings. Worldwide is doing a lot of ceramic stuff now too. See what they say, but OEM is fine. I'm not sold on the sealed ball bearing idea yet. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
main bearings | gassergrant | Enduro Engine - 2 stroke | 13 | 10-31-2012 03:44 PM |
How to remove main bearings and seals? | EricP | Enduro Engine - 2 stroke | 2 | 09-06-2011 11:18 PM |
Sealed main bearings? | hallam76 | Enduro Engine - 2 stroke | 25 | 03-16-2011 09:26 PM |
needle or main jet | skid jackson | Enduro Intake/Carburetion - 2 stroke | 3 | 10-30-2009 10:22 PM |
Main Jet Sizes? | ramcclure200 | Enduro Intake/Carburetion - 2 stroke | 2 | 02-23-2008 05:29 PM |