|
All Other Bikes... KTM, Husky, VOR, Husaberg & Hondayamazuki... |
|
Thread Tools | Display Modes |
#12
|
|||
|
|||
Progress on the Rekluse Basket
I had to press out the "starter gear" from the stock clutch basket. I used a spacer from my motion pro suspension tool and the old pressure plate(turned around) locked in my vice to push out the gear. it was tight but it came out without a problem. The Rekluse instructions specified heating the new Rekluse basket in an oven at 400 degrees for 15 minutes, and freezing the "starter gear", then push the "starter gear" into the Rekluse basket. I used insulated gloves from the kitchen, placed the basket on a piece of wood for support on the garage floor. I expected the bearing install into the Rekluse basket to be a pain, but the "starter gear" dropped right in without a problem.
Then I drilled out the rivets on the old basket to remove the stock ring gear. Note the grooves on the old stock basket, yikes.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar Last edited by Moto7man; 07-19-2017 at 10:31 AM. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DC conversion - not floating ground | johnm | Enduro Electrical & Wiring | 39 | 03-04-2020 11:11 AM |
Gas Gas Contact Jt 25 95 Restoration And Help | Eyetech | General Discussions & Announcements | 1 | 03-18-2016 03:33 PM |
2001 XC200 Restoration Project | Lincolnlock | Enduro Engine - 2 stroke | 19 | 04-22-2014 03:42 PM |
Hanging Idle after wide open | GasGas | Enduro Intake/Carburetion - 2 stroke | 10 | 09-06-2013 04:13 PM |
My Stomping ground | swazi_matt | Ride Reports | 10 | 03-02-2011 09:35 AM |