|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Quote:
Bruce
__________________
No one ever calls the Fire Department because they did something smart |
#12
|
|||
|
|||
Another solution to a problem similar to this is to check your piston, no not your engine piston but brake piston. If it has a lot of miles and has worn at an angle it will not push flat against the brake pad. You can machine it, or sand it flat and it will apply equal pressure on the pad eliminating sponginess.
Figured I would add this in case it gets a sticky |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Brakes | redrider7202 | Enduro Chassis & Body | 5 | 04-05-2010 05:45 AM |
torquing cylinder base nuts.... | stainlesscycle | Enduro Engine - 2 stroke | 17 | 03-08-2010 06:42 AM |
VisionX Solstice LED driving lamps | GMP | Enduro Electrical & Wiring | 11 | 01-14-2010 10:07 AM |
Grabby front brakes | rpduc | Enduro Chassis & Body | 11 | 05-28-2009 08:39 AM |
No Rear Brakes!!!!! | matt4wheels | Enduro Chassis & Body | 5 | 04-21-2007 02:06 PM |