|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
shifter shaft c-clip
I have an after market shift lever on my newly purchase '03 ec250, and need to get a c-clip? to install in the shift shaft groove. Can someone please let me know what size it should be? Thanks in advance, Bob.
__________________
'14 Beta 300rr '05 GG DE300 '03 GG EC250 '01 XR440 '09 FZ1 |
#2
|
||||
|
||||
You really don't need that c-clip.
It's there to keep the shifter from sliding off. If the shifter is that loose, it will strip out anyway. |
#3
|
|||
|
|||
So just make sure the shifter is cynched down good? I could use some locktite also. Thanks.
__________________
'14 Beta 300rr '05 GG DE300 '03 GG EC250 '01 XR440 '09 FZ1 |
#4
|
||||
|
||||
I'm too lazy to go measure mine right now, but I'd guess 8-9mm. Like Girard said its not critical, you could go get the closest standard size in a local hardware store and it would be fine.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Masterlink...Rivet or Clip | Rick | Enduro Chassis & Body | 9 | 11-27-2009 07:17 PM |
How to Embed video clip | 2 strokes 4 life | General Discussions & Announcements | 2 | 01-29-2009 11:19 PM |
Euro Enduro Clip | Rick | Pictures & Videos | 1 | 12-09-2008 05:55 AM |
helmet cam clip | fury1 | Pictures & Videos | 2 | 11-20-2007 04:42 PM |
Clip position ? | thingymijig | Enduro Intake/Carburetion - 2 stroke | 3 | 03-01-2007 04:57 AM |