GasGas Riders Club Forum  

Go Back   GasGas Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 02-13-2008, 03:03 AM
goody goody is offline
Member
 
Join Date: Aug 2006
Location: Carshalton, Surrey, UK
Posts: 10
Default Ec200 Bottom end.

I posted this on the smackover site but had no replies (it's been very quiet on there recently!)

I'm going to be replacing the mains on my 03 200 over the next couple of weeks, what's the best thing to do with the big end bearing a friend recently put new mains in his 250 but left the big end as it felt ok. I was thinking while the engine is stripped it would be worth doing but looking at the parts list it seems you can't buy the bearing separetely so do you need a new con rod kit? if so GasGas or hot rod etc. is the cr250 one the same?
Also looking at the parts list the 200 uses two ball race mains instead of the 250/300 ball race and roller, is there an option to upgrade my setup or just leave it.
Cheers Steve.
PS Whilst mine was out of action a friend loaned me his 03 Husaberg 400
to do a fairly tough enduro, it was awesome! got my best result ever.


__________________
Steve
04 EC300
96 JTR160
Reply With Quote


Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
loose bottom marzocchi cap noobi Enduro Suspension 2 06-06-2010 07:48 PM
Stripped bottom of Ohlins prk03 Enduro Suspension 8 01-25-2009 09:03 PM
Bottom Shock Mount PEB Enduro Suspension 6 10-12-2007 04:13 PM




All times are GMT -5. The time now is 08:46 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org