|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
11-07-2010, 09:36 AM
|
|||
|
|||
2000 EC300 Clutch
Hi Guys,
Newbie to the forum. Having migrated from a WRF450 to a EC300 I have a couple of questions on the clutch. I do some roadwork in the UK, occasionally having to sit in traffic. If I hold the clutch in for any length of time in gear it will just start to burn the clutch and stall. Then have to put into neutral and re-start, pretty enbarassing at lights and islands. Is this normal? Also the bike won't go into gear cold, or will do but with some persuading. Fine when warm however. Are the two linked? Clutch worn too much? Any help would be appreciated 
|
| Tags |
| clucth, engine |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ec300 2000 model user manual | cjcj121 | Enduro Other... | 4 | 10-09-2010 12:54 AM |
| EC300 Clutch | BULTACOBRIS | Enduro Engine - 2 stroke | 15 | 04-05-2009 12:13 PM |
| ec300 clutch problem | dirtjunky_uk | Enduro Engine - 2 stroke | 13 | 02-27-2009 08:08 AM |
| 2000 XC250 CDI for a 2001 UK EC300 | krazy | Enduro Electrical & Wiring | 1 | 09-14-2008 04:58 PM |
| 2000 ec300 Plastics | firckin | Enduro Chassis & Body | 2 | 06-03-2007 01:29 PM |
Threaded Mode