|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
help please ref connections on barrel
There is two connection on the barrel one next to the exhaust and one on top of the power valve housing which are identical except one has a smaller hole in than the other which one goes were thank-you In advance.
|
#2
|
||||
|
||||
Those are PV drains (left side) and gear box (right side) vents. Hoses drape down either side of the exhaust under the motor and rest on the skid plate.
__________________
Phil (New bike pending...) |
#3
|
||||
|
||||
I had to read that about 4 times to work out what you're saying, but I think I've worked it out. I don't have the answer 100% correct, but I know GMP knows the answer.
Basically, you're asking which nipple goes where for the rubber tubes which run from the cylinder. The one of the left hand side is the drain for the powervalve. The one at the top on the right hand side powervalve cover is the vent for the clutch and gearbox. I believe the larger hole'd nipple goes on the right hand side (but thats just from memory). |
#4
|
|||
|
|||
connections
cheers i removed both nipples from the barrel before i sent it for repair ,didnt realise one had a smaller hole than the other thanks again
|
#5
|
|||
|
|||
Large bore nipple goes on the right side (vent). Small bore nipple goes on the left (drain). Just installed mine a few days ago and I had noted the difference when I removed them.
__________________
2011 EC250E |
#6
|
|||
|
|||
nipple
Thanks I should of known better and checked
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anyone got a review of the 2013 race with the new barrel | Simmo737 | General Discussions & Announcements | 13 | 02-03-2013 04:08 PM |
What "size" piston without removing barrel | Eugene | Enduro Engine - 2 stroke | 20 | 01-04-2012 10:55 AM |