|
|
|||||||
| Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
 |
|
|
Thread Tools | Display Modes |
|
#1
04-22-2010, 01:40 AM
|
|||
|
|||
FSR 450 valve check and timing chain
Hi i am about to check my valve clearances for the first time, the bikes done10,000ks and its not starting as well or idling as sweet during warm up.
I have read the great valve check guide on Thumpertalk for a DRZ 400, and from what i have been told the top end is the same, so i can use that as a procedure to check and replace shims if i need to. My question is when i am doing the valve check how do i tell if the cam chain requires replacement, is it simalar to checking a regular chain by pulling on it and see how far it rises up on the cam sprockets? i would presume that would be the time to check it, anyone go any suggestions? i have both Gas gas service manuals they just show the removal/ install, thats about it. 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 450 Fse Valve Train and Timing | twowheels | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 09-23-2010 06:36 AM |
| Marzocchi 45mm mid valve check plate | stay_upright | Enduro Suspension | 10 | 04-02-2010 12:37 AM |
| fse 400 valve timing ??????? | mcludd | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 08-29-2009 11:54 AM |
| HELP How do I check and alter timing? | wence | Enduro Electrical & Wiring | 3 | 05-09-2009 04:28 PM |
| How do I check port timing? | moff747 | Enduro Engine - 2 stroke | 1 | 04-08-2009 05:27 PM |
Linear Mode
