|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
07-27-2012, 04:20 AM
|
|||
|
|||
Rubber Intake Manifold EC300
Hi all, I've purchased a new rubber intake manifold for my 2003 EC300 and was just wondering if it made any differance which end went on, i.e. is there a specific end for the carb and one for the engine side or does it make any differance??
|
|
#2
07-27-2012, 12:09 PM
|
|||
|
|||
|
Mine has little arrows on it. But if the ID is the same it shouldn't make a difference.
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intake Noise | farmerj | Enduro Engine - 2 stroke | 10 | 11-21-2011 11:12 PM |
| Rubber straps | Rabbitist | Enduro Chassis & Body | 4 | 06-01-2011 05:10 AM |
| Intake rubber | spanner | Enduro Intake/Carburetion - 2 stroke | 4 | 12-23-2010 12:07 PM |
| 300 ec Intake rubber | Luke12379 | Enduro Intake/Carburetion - 2 stroke | 0 | 03-27-2010 09:34 PM |
Linear Mode
