|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Extended shifter or interchange??
I have been running the Hammerhead designs extended shifters on the last two bikes that I had and really like them. I have a size 12 foot. I know the EC125 shifter is a little bit longer then the one on my '00 EC300 but does anyone know if any other shifter would fit and then I could cross it over to a Hammerhead part number. Thanks for any info!
|
#2
|
|||
|
|||
Sorry, there isn't another shifter that "crosses over".
I do have a new 125 shifter that I am not going to use. I can send it to you to try out - if you like it, I'll sell it to you. If you don't like it, just send it back. jeff |
#3
|
|||
|
|||
Thanks Jeff, I sent you a PM.
Scott |
#4
|
|||
|
|||
I need a longer shifter badly
Where can I get a hammehead shifter for an 03 mc250? |
#5
|
|||
|
|||
As far as I know, hammerhead hasn't made one up for the bike - and may never get around to it...
The 125 shifter or the shifter off the late model bikes will give you more room. FYI - I had an '01 and found the stock shifter, the short one you have, works well with Fastway pegs in the lowboy position. IMS YZ lowboy pegs reportedly work well for guys with bigger feet too... jeff |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
seatcover interchange | Stoby | Enduro Chassis & Body | 3 | 09-04-2010 01:47 PM |
parts interchange 125/200 | stainlesscycle | General Discussions & Announcements | 2 | 12-14-2009 04:59 PM |
mc/ec125 rod kit interchange | Sierra Gasser | Enduro Engine - 2 stroke | 1 | 12-11-2009 07:44 AM |
Extended Rear Axle -450 Wild HP | Beardy | Other GasGas Bikes/Quads | 3 | 07-01-2009 07:43 PM |
Extended idle or fuel screw | super_rat | Enduro Intake/Carburetion - 2 stroke | 7 | 01-01-2009 09:02 PM |