|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2005 fse 450
Ok so my temp sensor went out and I over heated my bike, I stop the bike once I notice coolant from the over flow. I washed it, started up fine and put it in my garage. I replaced temp sensor today and it will not start, just occasionally back fires.
|
#2
|
||||
|
||||
You will want to check your water pump impeller - it probably "melted"... A machined aluminum replacement with better flow quality is available as a replacement.
Can't help you on the no start issue - in older models, turning off the key for a minute or two would allow the ecu to reset and get around a hard start issue. jeff
__________________
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
I have a 2005 FSE | NORTH GA GASGAS | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 03-07-2011 11:39 AM |
2005 ec 125? | kneehurts | General Discussions & Announcements | 2 | 12-18-2010 12:47 AM |