Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 08-03-2011, 12:51 AM
Dude Dude is offline
Senior Member
 
Join Date: Jan 2011
Posts: 110
Default Jug sizes

IS the 250 and 300 jugs the same. Meaning can you bore the 250 jug to 300. If so will the 300 head work on the 250 jug thats bored? Planing on dropping a 78mil piston into a 250 setup should net 330. Would need to add material to head though for that.


Reply With Quote


Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Seal sizes kendunn Enduro Chassis & Body 0 12-19-2010 10:22 PM
bearing sizes pv ? stainlesscycle Enduro Engine - 2 stroke 3 08-23-2010 08:38 AM
Main Jet Sizes? ramcclure200 Enduro Intake/Carburetion - 2 stroke 2 02-23-2008 06:29 PM
New knobby sizes gasgasman General Discussions & Announcements 2 11-29-2006 05:10 PM
Pampera Wheel Sizes clangstone Other GasGas Bikes/Quads 0 11-05-2006 05:01 AM




All times are GMT -5. The time now is 10:20 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org