#21
|
||||
|
||||
Sure ill snap a couple shortly
__________________
trevor |
#22
|
||||
|
||||
Here's the pics of the damaged basket.
__________________
trevor |
#23
|
||||
|
||||
It was definetly time for a new basket
__________________
trevor |
#24
|
||||
|
||||
Wow, that is some serious wear! I have years and years of racing the Japanese brands (125, 250 and 500's) and have never seen a basket start to come apart like that between the fins.
Is that "common" with Gassers?
__________________
Believe nothing, no matter where you read it or who has said it, not even if I have said it, unless it agrees with your own reason and your own common sense. [Buddha] |
#25
|
||||
|
||||
I have around 200 hrs on this basket and 4 clutches. I must say the extent of the damage was likely increased due to my negligence after my last clutch blew. I didn't take the basket out to inspect it and then proceeded to blow another which had me tear it down. The damage was likely amplified after the second clutch was installed and blown
__________________
trevor |
#26
|
||||
|
||||
Hi guys anyone with the rekluse core manual tell me how the stack goes in? I thought the skinny .040 steel went in first then alternate with .060 plates 7 of them then end with a fibre for a total of 8 fibres. So am I right? I took the thing apart so long ago and can't remember and can't find the document on rekluse site any help would be great
__________________
trevor |
#27
|
||||
|
||||
Historically gassers have had about the most durable clutch out there - much better than the jap stuff imo but the last 4-5 years there has been different stock clutch baskets (maybe from different suppliers) and some have had issues.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Auto clutch Install, Rekluse or S3 Clutch Basket? | Moto7man | General Discussions & Announcements | 49 | 11-24-2013 12:41 AM |
New Clutch Basket | Rick | Enduro Engine - 2 stroke | 0 | 05-22-2011 09:30 PM |
125 clutch basket | GasGas | Enduro Engine - 2 stroke | 1 | 09-08-2008 10:46 PM |