#41
|
|||
|
|||
Quote:
|
#42
|
||||
|
||||
Get american friend to buy needle.6usd shipping.
|
#43
|
||||
|
||||
Yep, and it'll fit right into a normal postal envelope.
No local suzuki dealers where you are? |
#44
|
|||
|
|||
I have but they tell me i should wait 30-45 days. The same ktm and yamaha
|
#45
|
||||
|
||||
I'm in Australia, and even when there is no stock in the country its only 3 weeks max from Japan. Seems a bit on the long wait side of town.
|
#46
|
|||
|
|||
Quote:
I went with my old lady today, Husaberg FE450 2006 Again bad riding but working and trying to learn. http://www.youtube.com/watch?v=30_d0-0m5RQ |
#47
|
|||
|
|||
Hello Guys...
I got needles today but suzuki is not nedj. It is necj . It seems this needle abit leaner than nedj. An i have yamaha n3cw . What is your offers with them? I am going try mj 175, 38 and 2nd clip for needle ? |
#48
|
|||
|
|||
NECJ and NEDJ are the same needle, just half a clip difference. NECJ clip 3 = NEDJ clip 3.5
__________________
Current: 2014 Gas Gas EC300R _____________________________________________ Previous: 2011 Gas Gas EC300 ELC 2004 KTM 300 EXC |
#49
|
|||
|
|||
So is it most suitable to use 3rd clip position for necj?
I tried my gasgas today with this settings Mj 175, needle 42 and 2. Clip with necj. Iddle rpm was so high so i setted air and iddle again. Air 2 out. There is not much smoke. I suppose smoke is a good thing for two strokes. and a little bit oil at pipe. The oil so much before. No passing at high rpms and going so smooth. I am afraid to use lean. I am going to capture a video tomorrow. Thanks. |
#50
|
||||
|
||||
Those settings should be pretty close. I have and am running leaner settings on a 2013 250R which gets ridden quite hard. If the jetting is right there shouldn't be much smoke when up to temp, and little spooge.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2013 ec250r | Jakobi | Enduro Intake/Carburetion - 2 stroke | 2 | 04-17-2014 08:08 PM |
2011 Gas Gas EC250R | EricW835 | Used Bikes | 3 | 10-20-2013 10:58 AM |
2012 300 e start issue | schlitzy | Enduro Electrical & Wiring | 2 | 08-31-2013 03:07 PM |
EC200R vs EC250R (2012 model) | Jakobi | General Discussions & Announcements | 30 | 02-11-2013 03:41 PM |
2012 300 issue | bones150 | Enduro Intake/Carburetion - 2 stroke | 7 | 06-22-2012 12:29 AM |