|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
|
Thread Tools | Display Modes |
|
#11
02-21-2018, 08:43 AM
|
|||
|
|||
Interesting--yes, I have it on the "rainy" setting (which is where it was set when we got it). I assumed that would be the more torque'y/lugging way to go. I will definitely switch that over and give it a comparison run.
Interesting that the needle I'm currently using doesn't seem to be as commonly used among the Gas Gas riders as it is in KTM's etc. The P.O. had the NEDW installed, so I will go back and give that a try. Good stuff, as always!
__________________
11 Gas Gas 300 EC 17 KTM 690 E 08 KTM 300 XCW 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carb jetting 200 EC | maclab56 | Enduro Intake/Carburetion - 2 stroke | 10 | 05-10-2016 05:40 AM |
| No rear brakes - troubleshooting tips | CombatYoga | Enduro Chassis & Body | 1 | 06-11-2015 09:58 AM |
| 98 ec250 carb and jetting | OKFiremanMark | Enduro Intake/Carburetion - 2 stroke | 5 | 07-22-2013 04:00 PM |
| 2013 EC 250 carb/jetting | Earwinder | Enduro Intake/Carburetion - 2 stroke | 4 | 05-20-2013 04:35 AM |
| Jetting: 2011 250 (38mm carb ASII) | Jakobi | Enduro Intake/Carburetion - 2 stroke | 53 | 07-23-2012 06:31 PM |
Threaded Mode