|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Crank rebuild?
My '02 GG 125xc crank bearings have been a bit clattery for a while - thinking of doing the bottom end over, and I'd image that the crank is getting tired too. Where is a good place to get a crank rebuilt (New England a bonus)?
JayC |
#2
|
||||
|
||||
You could start by giving Les a call at LTR......
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#3
|
|||
|
|||
Andrew Cooksey at cookseycranks in TX does good work too; don't have his contact info but you can google him.
__________________
'73 H-1 500; '93 KTM 550 ; '96 KTM 550 ; '01 GG 280 Pro; '04 GG DE 300 |
#4
|
||||
|
||||
Personally I'd send it to RB Designs. YZ125 rod kit, nothing special about it.
|
#5
|
|||
|
|||
+2 for Andrew Cooksey. Awesome work and great prices.
|
#6
|
|||
|
|||
'Kay -
I have some of LRTs work and...I'm not a big fan. I contacted the other two guys - both seem willing, but neither seem to have much GasGas-specific experience, not that it matters, although I'd have to dig up a rod myself in both cases - neither can verify the YZ125 rod swap (and here is the first I heard of it myself). Incidentally, Cooksey is $20 more expensive than RB ($75 shipped vs $55 shipped). Cheap either way though. GMP - Any verification of the YZ125 kit available? I'm also still wanting to try a complete '89-99 CR125 clutch swap. I've heard mixed reviews on direct compatibility for the clutch. JayC |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Crank seal gone on rebuild? | stay_upright | Enduro Engine - 2 stroke | 11 | 09-13-2009 03:49 AM |
Crank Bearings? | GasGas | Enduro Engine - 2 stroke | 1 | 07-13-2008 03:24 PM |
Crank Seal | kim | Enduro Engine - 2 stroke | 2 | 05-18-2008 09:41 PM |
crank bearings | steve | Enduro Engine - 2 stroke | 0 | 02-06-2008 02:51 PM |