|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-11-2008, 06:42 PM
|
|||
|
|||
bent pipe.
Had a goodcrash yesterday and bent the pipe so it now touches the radiator pipe. Can I rebend the pipe so it's more or less back to original shape.
Would I leave the pipe on or take it off or leave it on the bike. Pipe is a messico. Thanks 
|
|
#2
10-11-2008, 08:23 PM
|
||||
|
||||
|
Did the same thing to the same pipe. All i did was take a com along and secure the bike and put the come along to the bent part of the pipe and ratcheded it out.
__________________
2002 Gasgas EC250 (gone not forgotten) 2012 Ktm 300xc 2001 Gasgas EC300 Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!!
|
|
#3
10-11-2008, 11:14 PM
|
|||
|
|||
|
I would be carefull yanking the pipe around while it is still attched to the bike. Seems like you could put alot of leverage into the spigot that is bolted to the aluminum top end. Just my $.02. On the 02 I pulled the radiator tubes away from the pipe with zipties.
Paul
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gear Selector Shaft Bent? | iancp5 | Enduro Engine - 2 stroke | 11 | 03-29-2009 04:39 PM |
| 06-07 GG OEM Pipe . Or . 07 Black Standard Pipe | gasser250sm | Enduro Engine - 2 stroke | 5 | 02-06-2009 01:07 PM |
| Radiator Bent | Niloz | Enduro Chassis & Body | 1 | 11-10-2008 01:18 PM |
Linear Mode
