|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Milling out triple clamps?
Anybody do this,, I've seen mention of this, heard bad and good.. I need to mill out 1mm diam in the lower clamp to fit the set of zokes I have. They are 58mm,, The WP are 57mm? and what are the ohlins/zokes/sachs,, if any of these are 58 or 58.5(I could shim) I'd feel better than milling them..
Thanks,,
__________________
Steve 16 Beta 350rr 04 KTM 525 sx/exc gone 03 KTM 625 sxc-rehab unit-did its job and now gone 03 GG 250 ec-gone 97 GG 250 ec Gone |
#2
|
||||
|
||||
Milling the clamps is absolutely okay. Measiring the clamps for an accurate number will be important, but this isn't a piano, you can be slightly over or under your number, that's what the clamp is for. I'd feel way better about milling 1mm out of a clamp than clouging up a shim.
__________________
Mike Sheetz OMRA #21AA What will I be riding next? Christini GG 300? '15 KTM 300 XC-W '08 EC 250 (Gone to new happy owner) Gran Prix Cycle LTR Suspension RB-Designs |
#3
|
||||
|
||||
Sachs Forks OD at Clamps
Quote:
__________________
Steven Beane #275 PlusOnePerformance - Superior Service the World Over - Dearborn MI AMA District 14 (Michigan) Officer afterhourscycle.com Michigan's Beta and TM Race Headquarters |
#4
|
||||
|
||||
To do it right, they should be line bored.
Meaning the holes in the upper and lower clamps are true and straight to each other as the're mounted on the bike, if one is off by just a degree or two that could mean 1/4" or more from clamp to clamp...and that will cause all sorts of problems. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bitchin' triple clamps available?! | robinator | Enduro Suspension | 0 | 05-08-2009 09:43 PM |
Triple Clamps clearance- Does this looks right?! PIX INSIDE | alexpp | General Discussions & Announcements | 8 | 04-15-2009 09:14 PM |
triple clamps compatible? Showa vs Zokes | enducross | Enduro Suspension | 0 | 06-17-2008 11:10 AM |