|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Starter clutch / gear problem
I sheared off a load of little screws holding a gear to the back of the flywheel. I assume this is the infamous sprag clutch?
Also heard I could get the necessary parts direct from Ringspann and it's a lot cheaper. Checked the thread out on here and the Ringspann part number discussed is for 03 or 04 I think but mine is an 06. Not sure if this is the same part. Can anyone advise me what is the correct Ringspann part number for an 06? I should state I am assuming a lot here as until I get the flywheel remover I can't examine the part properly but it is all the little screws that seem to have sheared - I'm guessing this is the starter clutch that's failed?? Can anyone enlighten me? Another question - what size is the flywheel puller for the 450? M30 x ? Thanks! Last edited by iancp5; 10-05-2009 at 02:54 AM. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2002 ec400fse starter clutch | jason r | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 09-09-2009 04:47 PM |
gear problem | new gas gas | Enduro Engine - 2 stroke | 2 | 01-06-2009 09:53 AM |
EC 125 Gear Shifter Problem | jonnyweston | Enduro Engine - 2 stroke | 6 | 09-17-2007 11:41 AM |
ec125 2002 changing gear problem ? | fastfilli | Enduro Engine - 2 stroke | 8 | 05-20-2007 09:13 AM |
Gear box problem 07 ec300 | peterr | Enduro Engine - 2 stroke | 5 | 02-26-2007 01:07 AM |