|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Top end tips and powervalve?
Just about to do my top end since it is my first on the GG I would appreciate some tips of what to look out for. Have already noted that I need to grind down my socket to fit the cylinder head nuts
Also seen that my pv has some slop so will go through the thread on that, but also noted that the pv shaft moves a bit from side to side is that normal or does it also need to be checked - I am sure I saw a YouTube vid of someone shimming it but not sure Any good YouTube links will be much appreciated thanks
__________________
2003 txt250 Pro 2013 Ossa 280i |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
on trail, need tips! | pscook | Enduro Intake/Carburetion - 2 stroke | 5 | 12-20-2011 02:09 PM |
First enduro ever...tips/suggestions? | sled_fiend | Off Road Racer's Corner | 8 | 07-10-2009 08:55 AM |
Winterizing Tips? | gasIdaho | General Discussions & Announcements | 5 | 12-05-2007 10:14 AM |
EC 200 set-up tips needed | bondo | General Discussions & Announcements | 20 | 10-23-2007 01:15 PM |
silencer tips | mgrumke | Enduro Engine - 2 stroke | 1 | 07-03-2007 04:34 PM |