|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
The head seal should just be a matter of selecting the proper oring, just like the pre '10. The idea is to get a seal between the top edge of the neck and underside of the cup. I remove the powdercoat to do this. I see no reason way it can't work on the new frames as well.
|
#12
|
||||
|
||||
Glenn. That would work.
A seal that is made into the cup would be even better. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
04 gasgas 300ec | Moto-x | Enduro Chassis & Body | 0 | 03-27-2011 10:47 PM |
'02 300ec | Bultaco206 | General Discussions & Announcements | 2 | 01-23-2007 06:40 PM |