#1
|
|||
|
|||
BTSL seal
Have a 05 250exc with bad crank seals. The standard part has a BTSL ending that I cannot find in my local bearingshop.
Does anyone know if a identical BA, BASL, B1 seal does the same?
__________________
07` EC300SM. 09` KTM 250EXC. 70`CB350 |
#2
|
||||
|
||||
The letters at the end of a bearing part number refer to the type of seal that bearing has. I would guess that "SL" at the end of your part number is an abbreviation for "single lip" meaning that it has only one contact point with the crank.
|
#3
|
|||
|
|||
I am familier with the combination of the seals listed, but the T in btsl puts me a bit of.
__________________
07` EC300SM. 09` KTM 250EXC. 70`CB350 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
gas cap rubber seal | evanchochrek | General Discussions & Announcements | 6 | 10-13-2014 11:10 AM |
Seal Size | tonyraft | Enduro Suspension | 1 | 04-30-2014 03:22 AM |
Has anyone on here used a seal mate? | KTMAndy | Off Road Racer's Corner | 10 | 04-25-2012 12:15 AM |
Seal sizes | kendunn | Enduro Chassis & Body | 0 | 12-19-2010 09:22 PM |
Crank Seal | kim | Enduro Engine - 2 stroke | 2 | 05-18-2008 09:41 PM |