|
Enduro Product Reviews Feedback & Comments on Products Tested |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
FMF Q silencer
I was getting tired of cleaning the screen on my Sparky spark arrestor which is on the end of a stock GG Euro silencer. I read that a ’99-02 KX FMF Q silencer would fit the GasGas, so I bought one off ebay.
The Q silencer is about as long as the stock GasGas Euro silencer (w/o the Sparky) and a few inches longer than the GasGas FMF TC2 silencer. Fitting the silencer on my ’06 EC300 required the following… > Trim ~0.2 inches off the end of the stock GasGas pipe. > Trim ~0.4 inches off the silencer tube where it slides over the pipe. > Slight trim of the rubber sleeve that fits over the pipe joint. > Bend the silencer body up a few degrees relative to the silencer pipe to get the mounts to align. > Bolt into place. The FMF Q tucks in well and provides adequate tire clearance. It fits pretty well except that the highest point on the silencer just touches the rear fender. I can’t hear a difference in noise level between the FMF Q and the stock GG Euro silencer with the rest of the engine noise. As a note, the KX FMF Q would not fit on my ’01 XC300 as it had too much interference with the rear fender.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
200 Vs 250 silencer / end can | iancp5 | Enduro Engine - 2 stroke | 1 | 06-04-2009 02:41 AM |
GasGas and the FMF Q silencer | Berkyboy | General Discussions & Announcements | 19 | 05-29-2009 12:00 PM |
MC Silencer on ab EC 250 '08 | GG27 | Enduro Engine - 2 stroke | 3 | 03-31-2008 11:16 AM |