|
Other GasGas Bikes/Quads Trials, Pampera, Wild HP, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
maybe it was just weak where the sensor went in.the guy at the trials store told me it was a common problem with that type of sensor also.... the rad cap is way different on this bike also..dont know for sure.. it was kinda different, i had been riding it about an hour waiting on a bud to show up, and i was just following him around on it.. nothing slow or hard at all..
the fan is 115.00... the sensor and housing is 117.00...
__________________
broken down over 60 slow rider.. |
#12
|
||||
|
||||
Ya know that's not too bad.
My fuel pump just went on my TE510...That little puppy is gonna be over $500
__________________
HuskyDude 10 EC300XC 08 TE510 07 TXT 280 77 TY175 |
#13
|
||||
|
||||
that is what i thought...i may try to do some looking around and try to change it to the newer style like yours also.. in the last few months there have been complete units on ebay rad,fans,all....none today
i am in amarillo tx, the closest trails dealer is in dallas.. sent him an email yesterday with my cel as a contact... he called me about 430 yesterday and was very helpful... the bike came from the dfw area... he knows it and the prev owner.. small trials bike world.. he told me a few other things to check also.. pretty cool jay
__________________
broken down over 60 slow rider.. |
#14
|
||||
|
||||
__________________
broken down over 60 slow rider.. |
#15
|
||||
|
||||
Quote:
Huskydude, I heard about some of these Husky issues. A Ducati pump/flange assy(as its sold) is over $900 , but the pump alone can be found as a generic off the shelf part for $150! Before I drop over $500 on a pump that will likely fail again(they just should not fail) I'd look at alternatives even if it means an external pump and regulator. Is that price for the flange assy? My Cannondale used the same pump as a Ford Ranger I could get anywhere for less than $100 and it never failed anyway. jhender3702, Same setup as my wife's '02 250 Pampera. Fan went bad from being jammed after a fall, and also took out the rectifier, so check that too. |
#16
|
||||
|
||||
that is what the guy at the trails store said.. check the rectifier also, but could not tell me how to check it...
any thoughts gmp ?
__________________
broken down over 60 slow rider.. |
#17
|
||||
|
||||
Well, ours was obvious as it had a big melted plastic blister on the side. I don't have the drawing/color codes handy, but if you do just use a DMM with a diode test mode from input to output. If I remember its just a simple half wave rectifier. If I have time I'll look at the Pampera tommorrow.
|
#18
|
||||
|
||||
Quote:
thank you jay
__________________
broken down over 60 slow rider.. |
#19
|
||||
|
||||
ordered parts today.... supposed to get them in a week or so...
cant wait to get my trial's back...
__________________
broken down over 60 slow rider.. |
#20
|
||||
|
||||
got the stuff in last night... got the same kind of thermostat.. i dont see what the retainer holds on to, to hold it in... it is pretty snug, but i think i am gonna safety wire it in or zip tie one of the two..
also the fan is a new design... gonna have to put the connector off my old one on it and re drill mounting screws... hopefully tonight i will get it back together..
__________________
broken down over 60 slow rider.. |
|
|