Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 04-21-2017, 07:16 AM
Zman's Avatar
Zman Zman is offline
Platinum Level Site Supporter
 
Join Date: Apr 2010
Location: Burbs of Chicago
Posts: 1,818
Default

If you have a stock bike you probably have a large squish measurement and you will pick up low and mid range power with little loss in top end if you use a thinner base gasket. If you have any ridge at the top of the cylinder you do not want to use a thinner base stack than what was in there previously because of possible ring snag at TDC.

While the factor stacks gaskets with few issues, I prefer the single gasket over a stack. Another option is to use some spray tack to glue together multiple gaskets.
Reply With Quote
 



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Base gasket 2011 EC300 Quigs Enduro Engine - 2 stroke 10 10-04-2015 04:58 PM
wet base gasket thejackrabbit Enduro Engine - 2 stroke 6 02-09-2014 01:03 PM
Base Gasket re-use? motogroove Enduro Engine - 2 stroke 5 06-26-2011 07:56 PM
2010 300 Cylinder Base Gasket Question coopernicus Enduro Engine - 2 stroke 12 06-22-2011 09:31 PM
Base gasket Ud_luz Enduro Engine - 2 stroke 21 05-09-2008 07:38 AM




All times are GMT -5. The time now is 02:46 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org