GasGas Riders Club Forum  

Go Back   GasGas Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 01-19-2011, 08:57 AM
case-racing case-racing is offline
Member
 
Join Date: Jan 2009
Posts: 55
Default piston 300 wild HP quad

ok so i have compression and the bike goes ok at full noise but has no mid power, and doesn't pull like it used too, when its facing down hill on a moderate slope it rocks over in gear so it is losing compression somewhere, I was going to change the rings in hope it might give me some more compression and more power, my nikasil is ok i suppose but was i was thinking is do i put a new pison and rings but do i bother with the nikasil, has anyone gone to a bigger piston in the 300 with no nikasil and if so what did you use and how did you do it. not all 2 strokes run it so i was wondering why we do. any help would be appreciated.

cheers bill


Reply With Quote


  #2  
Old 01-19-2011, 12:02 PM
hannesd hannesd is offline
Senior Member
 
Join Date: Jun 2010
Location: belgium,europe
Posts: 546
Default

get someone to check the cilinder for wear on the nicasil.
then get it measured properly and then decide wich over size piston to order.
if your piston is just in there, then you could maybe give it a try with only new rings...
Reply With Quote
  #3  
Old 02-03-2011, 11:53 PM
smoke229 smoke229 is offline
Member
 
Join Date: Jan 2011
Posts: 28
Default

almost all modern engines run nikasil because the bore lasts alot longer than the older borable cyliders. you normally just have to very lightly hone a nikasil cylinder instead of the old days of having the cylinder bored the next size at every rebuild.
you could have a borable sleeve installed in your cylinder but i wouldnt recomend it.
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
450 wild quad service manual ? dogsbody Other GasGas Bikes/Quads 4 06-19-2009 06:44 PM
quad engine parts for sale 450 wild 04 thumpercb Other GasGas Bikes/Quads 0 10-02-2008 08:54 PM
07 hp 300 quad quadinfamily Other GasGas Bikes/Quads 1 02-25-2007 03:00 PM
quad question jim360h6 Other GasGas Bikes/Quads 2 01-01-2007 12:08 AM




All times are GMT -5. The time now is 12:53 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org