|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gas gas 250 2011 speedo problem
Hello
I just got a GAS GAS 250 2T EC 2011. The bike is good. But I want to fix the speedo. I put new battery and its on when I start the bike. It starts count the operation time. But when I run off the bike, the operation time goes to zero again. Can you tell me why? And an other problem... The speedo has only one cable connected, the power one. The other 3, the temp and speed sensors are cutted. Can you tell me exactly where are they connected? |
#2
|
||||
|
||||
Try the Trail tech web site = trailtech.net
__________________
'12 XC 200 TTX Sold '15 XC 250E Sale pending |
#3
|
|||
|
|||
Didnt find any help at trailtech.net
|
#4
|
|||
|
|||
Had a trailtech once, the speedsensor is a hall sensor you på on the fork and a magnet etc on the brakedisc, the watertemp sensor i provided i a small tube, you cut a radiator hose and put it in between, but i found out that the stock temp sensor works just as well. This wass on my road bike and it han to have an constant 12v and a ignition 12v otherwise it would reset everytime after riding, dont know if this helps
|
#5
|
||||
|
||||
http://www.trailtech.net/instructions
The 2011+ came with a Vector in countries that received it OEM. 2010 and earlier used a Vapor. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2011 EC 125 Clutch slave problem | MCP540 | Enduro Engine - 2 stroke | 0 | 05-27-2014 02:56 PM |
2011 ec200 - speedo/tach/hr meter stock? | liv2day | Enduro Electrical & Wiring | 3 | 11-08-2013 05:32 PM |
Problem with Trailtech Vapor on 2011-EC300e | erniebearskin | Enduro Electrical & Wiring | 2 | 05-20-2012 08:53 AM |
Speedo problem on my Gasser | Klausen | Enduro Electrical & Wiring | 8 | 03-19-2011 03:21 PM |
2004 EC200 Speedo Problem | warnzie | Enduro Electrical & Wiring | 1 | 10-29-2007 06:29 AM |