|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
2011 starter voltage question
Electric starter hasen't worked on my 2011 gasser since I painted the frame 3 years ago. I figured I messed up my ground somewhere and never messed with it until today. The relay clicks and I have over 13 volts measured at the connection on the starter motor but it doesn't ever try to turn (even when I remove the bendix and it has no load). Also strange is the fact there is 6 volts at the starter even when the starter relay isn't activated. This makes no scense - any help would be much appreciated.
|
#2
|
||||
|
||||
Did you remove the paint on the frame at the engine mounting points?
6v at the starter indicates a voltage "back feed" , probably from the bad ground. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Starter (Motor) Question | farmerj | Enduro Electrical & Wiring | 8 | 10-19-2020 01:25 AM |
EC 300 2018 Starter motor question | eralha | Enduro Engine - 2 stroke | 9 | 10-08-2020 07:50 AM |
Starter question 2011 EC300 | iamovru | Enduro Electrical & Wiring | 3 | 02-17-2014 12:01 PM |
Clay, i have a WTF starter question on EC 300 2011 | rgranger | General Discussions & Announcements | 15 | 11-09-2013 12:20 PM |
Starter flywheel removal and nut question | andykr87 | Enduro Engine - 2 stroke | 2 | 01-05-2013 02:22 PM |