|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#71
|
|||
|
|||
Quote:
|
#72
|
||||
|
||||
N3EW vs N3EF
Same needle taper profile. The difference is in the straight section/needle diameter (0-1/8th throttle approx). The W is significantly leaner here. |
#73
|
|||
|
|||
I have just put a N3EG needle middle clip,in with a 38 pilot, 178 main, a/s at 1.75, and this is perfect for me. i played around with a NEDW but found it to soft off the bottom.
this is on my 09 250r, which also has the screw top AS I carb... in vico. |
#74
|
|||
|
|||
Quote:
I took the bike into the shop cos I needed it checked out after I tried heaps of different settings, they repacked the silencer and checked the PV, which was all good. They also changed the jetting including the needle (with out asking me) this is the setting they put in N3EF #3 MJ 175 PJ 40 I will take it out for good ride tomorrow. |
#75
|
|||
|
|||
Quote:
I changed to the NECW #3 and made a big difference. Runs alot better now, got good power but still has some things to be ironed out Current set up NECW #3 MJ 175 PJ 40 A/S 2.5 Its just a bit confusing how lean I have to run this bike considering I am at sea level. I still think it needs to be slightly leaner, maybe 38 pilot. Anyway today was great, best time I have had on it |
#76
|
||||
|
||||
Its not that lean, and my bike was always a bit of a lean freak too. In general I think being in Australia there seems to consistantly be a bit different to the states too. Must be the difference in fuels.
|
#77
|
|||
|
|||
Quote:
NECW #2 170 MJ 38 PJ A/S 2.5 Really nice crisp power off the bottom, mid range good, top end not 100% I have a feeling I could go to a 168 MJ which i will try after the next ride No signs of running lean yet. |
#78
|
|||
|
|||
Quote:
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sag setting question | Synergy-Seals | Enduro Suspension | 4 | 10-25-2011 04:40 AM |
Needle advice EC250 | darren | Enduro Intake/Carburetion - 2 stroke | 0 | 06-19-2009 03:00 PM |
Setting up my EC300R 09 | Keg | General Discussions & Announcements | 4 | 09-27-2008 07:42 AM |
Setting up my 05 GasGas EC250 | dozerash | General Discussions & Announcements | 2 | 09-26-2008 03:01 PM |