|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Jug sizes
IS the 250 and 300 jugs the same. Meaning can you bore the 250 jug to 300. If so will the 300 head work on the 250 jug thats bored? Planing on dropping a 78mil piston into a 250 setup should net 330. Would need to add material to head though for that.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seal sizes | kendunn | Enduro Chassis & Body | 0 | 12-19-2010 09:22 PM |
bearing sizes pv ? | stainlesscycle | Enduro Engine - 2 stroke | 3 | 08-23-2010 07:38 AM |
Main Jet Sizes? | ramcclure200 | Enduro Intake/Carburetion - 2 stroke | 2 | 02-23-2008 05:29 PM |
New knobby sizes | gasgasman | General Discussions & Announcements | 2 | 11-29-2006 04:10 PM |
Pampera Wheel Sizes | clangstone | Other GasGas Bikes/Quads | 0 | 11-05-2006 04:01 AM |