|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
EC 300 Racing 2014 Stator problems
Hi,
I have searched the forum but couldnt find any answers. I think that my stator is broken. The lights on the bike doesnt work but the bike runs good. I have 0V on the yellow and brown cable at the rectifier. If I ohm measure between thoose 2 cables i get 1,5ohm. Is the stator burned? What should the Ohm be between the cables? Can I put the Kokusan stator on? If so, can I take a stator from KTM? I think i should have the Ducati. |
#2
|
|||
|
|||
The Ducati rotor and stator were only used on the very early GG bikes (when the engines were counterbalanced). I don't know what wiring changes have taken place on the newest bikes, however you should check for AC voltage directly at the stator yellow wire.
You should get a reading of about 13V between the yellow wire and chassis ground with the bike running at a fast idle. If you have power there, then follow through the wires to look for a fault. The most common problem is a broken wire in the headstock area. This happens from the back and forth movement of the handlebars. I believe a KTM 2T stator can be used if you are willing to change the connections.
__________________
2011 EC250E |
#3
|
||||
|
||||
|
#4
|
||||
|
||||
You may want to do some research to determine if the older GG units will be a suitable replacement. Here is one of the older units. http://www.ebay.com/itm/Electrosport...pWT~r7&vxp=mtr
|
#5
|
||||
|
||||
These kind of responses make owning a gasgas a pleasure . You guys with all this knowledge and your quick resolutions make this board the great board that it is . So thank you for that and thank you Jeff for the time and effort you give free of charge .
__________________
IF I HAD ALL THE MONEY I SPENT ON DIRT BIKES , I WOULD SPEND IT ON DIRT BIKES |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2013 to 2014 racing ! | rubber Jonny | Pictures & Videos | 4 | 04-29-2014 01:53 AM |
still looking for help on the stator | KTMAndy | Enduro Electrical & Wiring | 9 | 01-02-2014 12:04 AM |
2k3 stator with cdi from 2k2 | whodat | Enduro Electrical & Wiring | 3 | 07-21-2013 10:34 AM |
stator rewinding | mountain thumper | Enduro Electrical & Wiring | 10 | 09-28-2008 02:26 AM |