|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
turbine core 2 silencer mounting...
do the mount tabs from silencer go inboard of the subframe mounts or outboard? it appears to fit both ways - if outboard, it'll melt plastics i think. if inboard it looks like tire might rub.
my powercore went inboard... if someone has a pic from the back side of their bike, i can figure it out
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#2
|
||||
|
||||
mine is outboard.. but it has the 2010 rear air box and fender, so that may not help much
__________________
broken down over 60 slow rider.. |
#3
|
||||
|
||||
the back of the number plate 'point' almost touches the silencer on 07..
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#4
|
||||
|
||||
that is kinda what i was thinking.. here is a Q on my 07.. it is nowhere close either.. it is bigger than the tc 2
__________________
broken down over 60 slow rider.. |
#5
|
||||
|
||||
Outboard, but I put a rubber spacer on the rear inside number plate to hold it off the silencer. The Q I had put a lot of pressure on the plastic, the Messico and TC2 not much.
|
#6
|
|||
|
|||
The TC2 fits on the outside of the sub frame mounts.It may touch the air box and the tyre will rub otherwise
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FMF Turbine Core 2 Silencer fitment | SpeedyManiac | Enduro Engine - 2 stroke | 2 | 06-23-2008 09:22 AM |
FMF Turbine Core 2 DB | sanderjavant | Enduro Engine - 2 stroke | 8 | 08-27-2007 07:58 PM |
FMF Turbine Core on '07? | GMP | Enduro Engine - 2 stroke | 4 | 02-21-2007 07:59 PM |