|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Is clutch basket position critical on re-assembly
Rebuilding 300 after main bearing failure. Read workshop manual after stripping, oops, and it states mark clutch basket before removal to ensure correct position on re-assembly. I didn't mark it! I cant see anything that requires alignment on assembly but have I missed something. Any advice welcome.
cheers, Simon |
#2
|
||||
|
||||
Not critical.
Same as when you replace the basket, no index marks. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2008 EC300 clutch assembly position | mwoody98 | Enduro Engine - 2 stroke | 0 | 03-13-2012 09:52 PM |
Clutch basket | c-152 | Enduro Engine - 2 stroke | 2 | 03-09-2011 04:51 PM |
clutch basket mod | stainlesscycle | Enduro Engine - 2 stroke | 5 | 02-09-2010 10:12 AM |