|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
|
Thread Tools | Display Modes |
|
#6
01-05-2014, 06:16 PM
|
||||
|
||||
What was your squish? Where was the piston in relation to the base of the exhaust port with the engine at bottom dead center? The specs I am using as above are the same as I use on my 2010 model with S3 cylinder and head using the black insert, however I had material machined out to reduce the compression ratio.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jetting (needles) 2013 gasgas ec 250 | nickp | Enduro Intake/Carburetion - 2 stroke | 7 | 11-03-2013 02:25 PM |
| 2013 250ec jetting uk | nickp | Enduro Intake/Carburetion - 2 stroke | 3 | 08-07-2013 04:56 PM |
| 2013 250ec jetting | nickp | United Kingdom | 1 | 07-16-2013 06:34 PM |
| 2013 250ec jetting | nickp | General Discussions & Announcements | 4 | 06-24-2013 05:00 AM |
| 2013 EC 250 carb/jetting | Earwinder | Enduro Intake/Carburetion - 2 stroke | 4 | 05-20-2013 04:35 AM |
Threaded Mode