|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gas gas 300 squish question
I have red alot about this.
I started another post about heating problem. I just installed a heating fan so there is no problems any more. I had 1,6 mm and the bike runs fine. Now i have 1,9 and the bike blurp alot, at low speeds and feels whay slower. And more fuel consumption. I have the correct jetting. On the other thread you tell me 1,6 mm is to much without machine head? How about s3 inserts? And another guy on this thread got down to 1,2mm without machine head? http://www.gasgasrider.org/forum/showthread.php?t=12558 I hope i can get a correct answer thanks.. |
#2
|
||||
|
||||
guess under 1.5mm with no compression correction might have pinging problems, extra heat and wear....etc
If you felt everything was right without the extra gasket on the 1.6, then stick to that till you find the chance to do the head properly...
__________________
EC250 2019 |
#3
|
||||
|
||||
Will depend on what fuel you can run. Here's my thread to read more. I get off topic to the end but it comes right.
http://www.gasgasrider.org/forum/showthread.php?t=16560
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#4
|
|||
|
|||
Quote:
Oki thanks, i red alot. The only thing i noticed is when going over 5-6 k rpm for a longer period it will sound wham wham wham on idle, and its idle a little bit higher. Thats the only negative thing i have noticed. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Yes, another squish question | 32:1 | Enduro Engine - 2 stroke | 4 | 03-15-2016 04:59 PM |
squish question | barossi73 | Enduro Engine - 2 stroke | 3 | 12-01-2014 12:03 PM |
1.6+ mm squish | paulos | Enduro Engine - 2 stroke | 8 | 07-08-2014 08:28 PM |
Squish help. | Ud_luz | Enduro Engine - 2 stroke | 39 | 02-14-2014 11:02 PM |
RIDICULOUS squish. as always! | stainlesscycle | Enduro Engine - 2 stroke | 30 | 10-19-2011 01:11 PM |