|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#21
|
||||
|
||||
Quote:
Point being, if your tester measures low, then the change from 148 to 150 seems like a waste of time, but it is more likely that the tester isn't accurate in the first place. |
#22
|
||||
|
||||
Quote:
__________________
2011 Gas Gas EC300 38mm, 2008 Husky TE610, 2003 Beta Rev3 250 |
#23
|
||||
|
||||
Also keep in mind that 300s have a compression bleed hole over the exhaust port for easier starting.
|
#24
|
||||
|
||||
There is a difference between compression ratio and cylinder compression. One is the volume of the combustion chamber, the other is the ability of the rings to seal. Just changing the volume does not change the ability of your rings to seal.
Also, did you hold the throttle wide open when testing? How many kicks did you give it before you took your measurement? |
#25
|
||||
|
||||
Quote:
|
#26
|
||||
|
||||
Quote:
__________________
2011 Gas Gas EC300 38mm, 2008 Husky TE610, 2003 Beta Rev3 250 |
#27
|
||||
|
||||
Quote:
Quote:
|
#28
|
||||
|
||||
Quote:
__________________
2011 Gas Gas EC300 38mm, 2008 Husky TE610, 2003 Beta Rev3 250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1st ride with RB Designs head and carb | ramcclure200 | Pictures & Videos | 4 | 08-30-2011 08:46 PM |
RB-Designs carb mod or PowerNow? | AZRickD | Enduro Intake/Carburetion - 2 stroke | 14 | 01-23-2009 05:50 PM |
RB Designs Carb Mod | Magellan | Enduro Product Reviews | 18 | 06-11-2008 01:44 PM |
RB Designs carb work | Eric K | Enduro Product Reviews | 0 | 08-21-2007 04:15 PM |
RB Designs Carb Mod? | Boomhauer | Enduro Intake/Carburetion - 2 stroke | 4 | 03-20-2007 03:09 PM |