|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2011 250 with a drinking problem...
Hello
Just rode my 1st enduro yesterday. DNF mainly due to lack of fitness lol Severe arm pump stopped me halfway up a steep 500m long climb and took 45mins to get to the top of it again! and stopping to help someone whose chain sucked up between front sprocket and swing arm. Anyway it was a 35mile lap, I hit reserve around 32miles. Route was mixture of service roads, rocky trails and slow technical forest section with a few road sections in between. Bike pulls well and idles perfect. Starts easily from cold with no choke, usually need throttle pulled to get some air in when hot starting (normal for 2t?). Quite spoogy out the exhaust. Not a fast rider so mainly a gear higher and working the clutch rather than singing on the pipe apart from the more open bits. Could pilot be a bit too rich?? Or am I better going whole hog and see what the squish is like and fix that? cheers |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gas gas 250 2011 speedo problem | dimtsam | Enduro Electrical & Wiring | 4 | 08-19-2014 03:03 AM |
2011 EC 125 Clutch slave problem | MCP540 | Enduro Engine - 2 stroke | 0 | 05-27-2014 02:56 PM |
I bought a 2000 xc and keep finding problem after problem | 675AZ | Enduro Engine - 2 stroke | 12 | 02-15-2013 07:25 PM |
Problem with Trailtech Vapor on 2011-EC300e | erniebearskin | Enduro Electrical & Wiring | 2 | 05-20-2012 08:53 AM |
Fuel range problem!!!Ec250 2011 | thomas.gr | Enduro Engine - 2 stroke | 4 | 03-03-2012 03:06 PM |