|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Putting a 250 top end on a 300??
Any one ever try it? If so, what kind of outcome was there? Waste of money? Quicker revving?
|
#2
|
||||
|
||||
This is an easy swap and the end result is that you get a 250. The bottom ends are the same for both the 250 and 300.
|
#3
|
|||
|
|||
Kinda funny actually.
|
#4
|
||||
|
||||
I've went both ways: made my "01"300 gasser into a 250 and my "07" 250 gasser into a 300. 300s have more bottom end but the 250 has plenty if you gear it a little lower than the 300. For me the 250 is definitely more fun and easier to ride. My current ride is a 2011 250.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Putting this out there WTB Rekluse, Lectron and radiator guards | Stoby | "Wanted to Buy" & "Want To Trade" | 5 | 11-14-2013 08:05 PM |
Is it worth putting grease nipples on linkage? | gasgas1999 | Enduro Suspension | 22 | 12-28-2012 03:34 PM |
Putting in new rings | 101racing | Enduro Engine - 2 stroke | 16 | 04-22-2009 01:21 AM |