|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Did you wash the cylinder with hot soapy water after you got it back from the platers? Sometimes they are a bit lazy and don?t wash them properly. And brake cleaner on a rag is not good enough. The hone lines it the cylinder hold a lot of microscopic honing grit etc.
Check for cleanliness with a wipe with a white rag and fresh engine oil. Should not be grey at all.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#12
|
|||
|
|||
I just washed it with a rag and some brake cleaner. Put a little bit of an oil coating everywhere and put it on.
|
#13
|
|||
|
|||
Quote:
|
Tags |
cylinder, piston |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ec 300 cylinder problem... | knutte112 | Enduro Engine - 2 stroke | 7 | 02-17-2014 11:13 AM |
problem 2002 ec300 wont rev out? | andy176 | Enduro Engine - 2 stroke | 17 | 10-07-2013 07:54 PM |
2006 EC300 problem | fury1 | Enduro Engine - 2 stroke | 29 | 06-09-2009 05:40 PM |
ec300 clutch problem | dirtjunky_uk | Enduro Engine - 2 stroke | 13 | 02-27-2009 08:08 AM |
Gear box problem 07 ec300 | peterr | Enduro Engine - 2 stroke | 5 | 02-26-2007 01:07 AM |