|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Friction plate part# ??
I toasted my clutch today (05' EC300) and need to get new friction plates. I hear Honda friction plates will work? Anyone out there have a specific part# or info that I can feed to my local shop. Thanks!!
|
#2
|
|||
|
|||
I ended up using Honda CRF450 friction plates. One thing to mention is that I'm running a Rekluse clutch so I had to use some thinner Rekluse drive plates to get the stack height/operating gap within spec. My friends do product development there. In their opinion, the stock Honda plates are as good as it gets based on their testing. They have seen situations where the GG plates get hot and the adhesive on the friction material breaks down and the pads start tearing off.Took her out yesterday and it performed flawlessly
|
#3
|
|||
|
|||
I have a 2011 EC 300. I am installing a Rekluse Basket and Rekluse Core Exp this week. Are GasGas OEM Fibers the best plates? Or is there a Honda crossover fiber plate that is just as good?
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#4
|
||||
|
||||
GG fibers are a little thinner than the Honda plates, so you wind up a little off of the pack thickness and may have to make some adjustments. I have had excellent results with stock GG clutch packs.
Sent from my iPad using Tapatalk HD |
#5
|
||||
|
||||
I know of some guys who race GG 300's. They use all OEM GG Fibers but then add just 1 CRF450 fiber at the outside (last one) of the stack. Supposed to provide a bit more hook up on the clutch.....
That being said that is for manual clutches only. As for your Rekluse - I would recommend to use GG OEM. Otherwise you might mess up the "Installed Gap" dimension that Rekluse recommends in order for their EXP to work properly.
__________________
2012 - XC 300 Racing Seattle, WA Last edited by StuJohnson; 06-16-2013 at 12:55 AM. Reason: correction of fiber stack |
#6
|
|||
|
|||
Quote:
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
To part it or not? | PEB | General Discussions & Announcements | 2 | 10-02-2008 05:03 PM |
Part 2: My next bike will be a ... | MattR | General Discussions & Announcements | 28 | 10-10-2006 06:59 PM |