|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
06-27-2014, 01:30 PM
|
|||
|
|||
Run time
On a new fresh piston, how many hours / miles would you expect an EC 300 to go between needing a new piston if you was using it for the odd weekend trail ride and using it to commute to work say 20 mile round trip via 30mph and 40mph roads
__________________
SUZUKI GSXR 1000 K6 GAS GAS EC 300 04 
|
|
#2
06-27-2014, 03:21 PM
|
||||
|
||||
|
Put 3000 varied miles on mine and then turned it into a 250 and the 300 piston was still good no loss of power, very small amount of blow by on the rings.
__________________
02 300ec- 50mm Marzocchi cc forks, 2010 plastic. Now a 250cc.
|
|
#3
06-27-2014, 05:37 PM
|
|||
|
|||
|
Cheers bud that's not bad then, what made you go to 250
Can you point me in a thread for your new style conversion Sent from my GT-I9300 using Tapatalk
__________________
SUZUKI GSXR 1000 K6 GAS GAS EC 300 04
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Time to say hello. | myoung | General Discussions & Announcements | 2 | 05-11-2014 07:47 AM |
| Time is wrong | Brian | Suggestion Box | 3 | 12-10-2009 03:33 PM |
| rebuild time?? | W8TSON | Enduro Engine - 2 stroke | 10 | 08-02-2009 02:05 PM |
| One Time Movie | Boomhauer | General Discussions & Announcements | 2 | 07-31-2008 10:09 PM |
| Your first time? | TooFastTim | General Discussions & Announcements | 23 | 02-17-2008 06:29 PM |
Linear Mode
