|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
base gaskets
do i need to disassemble the power valve to replace the base gaskets or judt unhook the pv pushrod never done this before so please excuse my ignorance
thanks guys |
#2
|
||||
|
||||
just unhook the pv rod. don't forget to drain the coolant
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com Last edited by stainlesscycle; 04-29-2010 at 04:19 PM. |
#3
|
||||
|
||||
cheers thanks very much
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Base Gaskets | Warwick Simpson | Enduro Engine - 2 stroke | 16 | 05-23-2009 08:16 PM |
125 gaskets | noobi | Enduro Engine - 2 stroke | 0 | 04-23-2009 05:08 PM |
'05 seat base | Loosenut | General Discussions & Announcements | 0 | 07-11-2008 12:02 PM |
Base gasket | Ud_luz | Enduro Engine - 2 stroke | 21 | 05-09-2008 07:38 AM |
Base Gasket | gtsnowcrack | Enduro Engine - 2 stroke | 6 | 09-09-2006 05:43 AM |